HARLEY DAVIDSON ENGINE-GUARD FOOTPEG BILLET MOUNTING KIT INSTALLATION MANUAL

download
INSTALLATION 1. See Figure 1. Position a footpeg mount (3) and clamp (1) on the engine guard. Position the footpeg mount (3) to allow the footpegs to fasten on the inboard side of the engine guard. 2. Apply LOCTITE® 243 (blue) to two screws (4). 3. Use the screws from Step 2 to fasten the footpeg mount in a comfortable location on the engine guard. Tighten screws to 14 ft-lbs (19 Nm) . 4. Install a footpeg, sold separately, using the spring washer (2), and bolt and locknut (from kit 94133-01). Position the spring washer inside the footpeg mount with the square edge toward the inside of the mount. Tighten locknut to 19 ft-lbs (26 Nm) . 5. Repeat Steps 1-4 on the other side of the motorcycle. SERVICE PARTS